Pride-mobility Wrangler User Manual download pdf (Page 32)

www.pridemobility.com Wrangler

VI. COMFORT ADJUSTMENTS

ARMREST ANGLE ADJUSTMENT

The armrests of your PMV can be adjusted upward or downward by turn-

ing the adjustment dial. See figure 14.

The armrests also pivot upward to make getting on and off of your PMV

easier.

NOTE: If your PMV is not equipped with a reclining high-back seat, as

shown in figure 12, you will be able to adjust the height and width of the

armrest by following the directions below.

ARMREST HEIGHT ADJUSTMENT

ADJUSTMENT

DIAL

Figure 14. Armrest Angle

Adjustment

Figure 15. Armrest Height Adjustment

You will need the following tools to adjust the height of the armrests:

• 5/32” Hex Key •1/8” Hex Key • 7/16” Wrench

1. Loosen the setscrew on the side of the height adjustment tube with the 1/8” hex key.

2. Loosen and remove the acorn nut and screw holding the height adjustment tube in place.

3. Raise or lower the height adjustment tube to the desired height.

4. Align the holes in the adjustment tube with the holes in the armrest upright.

5. Insert the screw through the holes in both the height adjustment tube and the armrest upright.

6. Install and tighten the acorn nut.

7. Tighten the setscrew on the side of the height adjustment tube.

8. Repeat for the other armrest.

ARMREST WIDTH ADJUSTMENT

The armrest width of your PMV can be adjusted inward or outward.

1. Loosen the armrest adjustment knobs at the back of the seat frame. See figures 15 and 16.

2. Slide the armrests in or out to the desired width.

3. Tighten the armrest adjustment knobs.

Figure 16. Armrest Adjustments

ARMREST ADJUSTMENTS KNOBS

SETSCREW

HEIGHT ADJUSTMENT TUBE

ARMREST

ADJUSTMENT

KNOB

ACORN NUT

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

No comments

Pride-mobility Wrangler User Manual Page 32