Pride Mobility Traveller Plus Owner's Manual download pdf (Page 33)

Elite Traveller Plus www.pridemobility.com

Any electromechanical device occasionally requires some troubleshooting. However, most of the

problems that may arise can usually be solved with a bit of thought and common sense. Many of these

problems occur because the batteries are not fully charged or because the batteries are worn down and can

no longer hold a charge.

DIAGNOSTIC BEEP CODES

The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting

quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below

develops.

NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel

Scooter has been turned off, then turned back on.

VIII. BASIC TROUBLESHOOTING

What if all the systems on my Travel Scooter seem to be “dead”?

 Make certain that the key is in the “on” position.

 Check that the batteries are fully charged.

 Push in the main circuit breaker reset button. See III. “Your Travel Scooter.”

 Make certain that the battery pack is seated properly.

 Be sure the power down timer feature has not been activated. See V. “Operation.”

 Check the tiller console fuse located under the battery pack.

FAULT CODE CONDITION SOLUTION

 (1)

Battery charge is low. Charge batteries as soon as possible.

  (2)

Battery charge is too low. Charge batteries.

   (3)

The Travel Scooter's battery voltage

is too high to operate the Travel

Scooter, or the charger is still con-

nected to the off-board charger port.

Unplug charger and/or turn key off,

then back on again. If traveling

down a slope, reduce Travel Scooter

speed to the minimum setting.

    (4)

Current limit time out. Turn the Travel Scooter off for a

few minutes, then turn your Travel

Scooter back on.

     (5)

The manual freewheel lever is in the

(forward) freewheel position.

Remove the key from the key

switch, then push the manual free-

wheel lever to the drive (rearward)

position and restart your Travel

Scooter.

      (6)

Throttle control lever not at centre

position at start up.

Return the throttle control lever to

centre position, turn scooter off then

back on.

       (7)

Speed pot error. Call your authorised Pride Provider

for assistance.

        (8)

Motor volts error. Call your authorised Pride Provider

for assistance.

        

(9)

Other internal errors. Call your authorised Pride Provider

for assistance.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Comments to this Manuals

No comments

Pride Mobility Traveller Plus Owner's Manual Page 33

Comments to this Manuals

Related products and manuals for Scooters Pride Mobility Traveller Plus