- 14 -
Your footrests are capable of being rotating inwards and out-
wards. To achieve this pull the release lever towards you and
rotate footrest in the required direction. Lift-off from upper
pivot point to remove.
Both armrests are swing-back detachable. To operate, push
the release lever forwards to unclip, and lift arm out of front
socket
This is an additional brake which is applied manually to the tyres when the chair
is parked in free wheel or in storage. To apply the brake, push the lever forwards
until the shoe is locked in place. Pull backwards to release.
This is available to reduce the overall height of the chair.
Whilst at
the rear of the chair, grip the small lever and push
down to release pin allowing the handle section to be folded.
The Powerchair has climbing power that
enables you to
overcome gradients of up to 12° (1:5).
Always approach an incline directly, not at an angle, and follow it
up or down directly avoiding zigzag movement.
CAUTION! - Never attempt to climb or descend an incline
which has a slippery or icy surface.
While going uphill or downhill there is no need for drastic cor-
rective joystick movements. The electronic controller ensures
th
at the extra power required for climbing is automatically ap-
plied to the m
otors, so that the selected speed is maintained. This
is achieved by the micro-computer of the electronic controller compensating
automatically for any extra power required.
The same applies when you travel downhill. The electromagnetic safety brake
gives you full control over your Powerchair at all times. This unique brak
e sys-
tem enables you to descend at a constant slow speed.
BE CAREFUL
- 13 -
The VR2 control system can be locked to prevent unauthorised use. The locking
method is via a sequence of key presses and joystick movements, as detailed
below: -
1) While the control system is switched on, depress and hold the on/off button
2) After 1 second the control system will bleep. Now release the on/off button
3) Deflect the joystick forwards until the control system bleeps
4) Deflect t
he joystick in reverse until the control system bleeps
5) Release the joystick, there will be a long bleep
6) The wheelchair is now locked
1) Use the on/off button to switch the control system on. The maximum speed /
profile i
ndicator will be rippling up and down
2) Deflect the joystick forwards until the control system bleeps
3) Deflect the joystick in reverse until the control system bleeps
4)
Release the joystick, there will be a long bleep
5) The wheelchair is now unlocked
User Manual
Pride Mobility R4 Power Chair
(20 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals